Zoning & Land Use Recommendations
Following the analysis of the existing zoning conditions and an assessment of the allowable uses and bulk standards associated with the New Castle County Unified
Development Code, the design team identified high-level zoning recommendations for the Concord Pike (US 202) Corridor. The recommendations are categorized into three major strategies. The recommendations are categorized into three major strategies, located on the map to the left:
The zoning recommendations identified within this document have been discussed with the New Castle County Land Use Department. All of the recommendations made are suggestions that may influence the re-write of the UDC. To be implemented, all rezoning would need to be officially reviewed and approved by New Castle
County.
On the map to the left, the preliminary recommendations are shown. Each layer may be turned on/off by clicking on the checkbox in the upper right corner on the map categories.
US 202 Land Use Recommendations
To meaningfully address the existing development patterns and guide appropriate future development, revisions to the study area's zoning based on New Castle County's Unified Development Code are recommended and outlined below.
Potential Areas for Neighborhood Preservation (NP)
Protection of residential neighborhoods and nearby areas through land use policy
Redevelopment Areas (TRA)
Areas to revise the redevelopment provisions of the UDC so as to encourage redevelopment consistent with the principles of Master Plan
Potential Historic Overlay District
Sites of Historic Interest - Structures
Sites of Historic Interest - Other
NRHP - Deemed Eligible
Properties deemed eligible for consideration for the National Register of Historic Places (NRHP) designation
Historic Overlay District - Existing
Current properties which are existing historic overlays
NRHP - Listed Districts
Areas which are currently listed on the National Register of Historic Properties
Center your desired location under the cross hairs and click the launch streetview button.
Measure distances
Measure areas
Selection Table